
handle battery assembly.
5. Replace the battery door and screws and turn the reader on using the ON/OFF switch.
6. It is a good idea to fully charge the new battery(s) before first use.
Recharging the battery:
1. With the RF Terminal shut off, plug the 5V power adapter into the RF Terminal using the supplied
adapter cable.
2. The RF Terminal will turn On and display the following message:
Charging Battery
Please Wait………..
3. When the battery is fully charged after 2-4 hours the following messaged is displayed:
Battery Charge
Complete
4. The unit will remain ON for a half hour or so after the charge cycle has completed and then turn
OFF.
5. If you press the POWER key while the unit is charging, nothing will happen.
6. If you press the POWER key after the unit has turned OFF after completing a charge cycle and the
charger is still attached, the “Charging Battery” message will display again and a charge cycle will
begin.
7. It will take about 2 hours to fully charge a unit with a single battery and about 4 hours to fully charge
a unit with the optional handle battery.
8. Do not charge the battery if the Terminal is very hot or very cold since this will give a false reading
on the condition of the battery and it may not get charged properly.
9. You cannot operate the unit when the charger is attached, except to charge the battery.
Wi-Fi RF Terminal Menu Functions
Upon power-up, the Wi-Fi RF Terminal displays the following opening screen:
Wi-Fi LT7802 - xxxx-Hyy-zzzz
Host:000.000.000.000:0000
Term:000.000.000.000:0000
SSID:
1. SIGN ON
2. SETUP
3. SITE SURVEY
(The opening screen can be bypassed upon power up. See Chapter 2)
• On first line on the screen, xxxx, gives the firmware revision number.
• Hyy indicates the version of the hardware.
• The Wi-Fi security type is shown at zzzz.
• Host: is the host server IP address.
• Term: is this Terminal's IP address (all 000's for DHCP).
10
Komentáře k této Příručce